BennVenn's Digital Backlight Brightness Controller Installation Guide for GBA

Gameboy Advance -

BennVenn's Digital Backlight Brightness Controller Installation Guide for GBA

This tutorial is still a work in progress. Please, don't hesitate to reach out if you want to help with this guide. 

Table of Content

  • Change Log
  • Introduction
  • Where to Buy?
  • Installation

Change Log

[0.0.1] - 2018-05-01

  • Simple picture install

    Introduction

    The following tutorial will guide you through the steps to install our BennVenn's Digital Backlight Brightness Controller (DBC) inside a AGB-001 console.

    The current revision consist of only an image but will be detailed in the upcoming weeks.


    Where to Buy?

    If you don't already own our BennVenn's Digital Backlight Brightness Controller, they can be found here.


    Installation

    1. Wire the DBC (on left) as depicted on the picture (disregard the GBAccelerator on the right).

    2. Follow our AGS-101 Voltage Regulator Connection Guide to properly isolate the AGS-101 LCD's backlight. During the process, instead of wiring the LCD's negative pad to the battery terminal, connect it to the DBC's LCD pad. 

    BennVenn's Digital Backlight Brightness Controller


    Leave a comment

    Please note, comments must be approved before they are published