High-quality backlight kits are a compatible size for both the original Game Boy - DMG and Game Boy Pocket - MGB.
- 7 COLORS IN ONE BACKLIGHT - Red Green and Blue individually controlled LEDs for the ULTIMATE CUSTOM GAMEBOY
- Tune to your favourite colour and leave installed or set up with a 4 Position DIP Switch or BennVenn's RGB Controller Board to ADJUST ON THE FLY
- FLEXIBLE PRINTED CIRCUIT BOARD
- LARGE SOLDER PADS
- Backlight Panel
- Polarisation Film
- 150ohm resistor (Red)
- 2 x 100ohm resistors (Green and Blue)
- Install the polarisation film with the concave side facing the LCD (UP) and the convex side (which has a blue stripe on the protective film) facing the backlight panel (DOWN).
- Remove the protective film from BOTH SIDES of the polarising film and from the FRONT of the backlight panel.
- Use our 4 position DIP switch to constantly control the colour of your backlight - connect each colour to ground to illuminate - 7 colours to choose from, any time you like.
- ...or even better: BennVenn's RGB Controller Board.
- Installing a backlight reduces the perceived contrast of a dot matrix LCD - we recommend also installing a Gameboy Bivert Board to get the best results.
Supplied by Deadpan Robot.